dyno'd and tuned, and dyno'd and tuned

had some cars on the dyno for just pulls, others for tuning great mix!

ryans home made blower kit up and running and making boost

steves 5.3 turbo GN

better video of marks 8.11@170 in and out of car

Mark goes 8.11@170 today!

video is 8.13 pass but 8.11 slip is at the end of the video! 7s soon!

mark going 8.80s @ 160 at night

firing the boat anchor on the floor with microsquirt

broken stud removal tool

pretty neat tool my neighbor has for removing broken exhaust studs

Matts 79 corvette with 01 4.8 and 60e, trickflow cam

finally got this worthy to come up to the dyno for a tune and messing around, 242 hp to the tire, stock 01 4.8 and 60e out of a truck, trickflow cam, pac1218 springs, stock truck intake, manifolds etc etc, great power on 87 octane going to be a hell of a driver, does 65~mph at 2000 rpm in overdrive. cant wait till he gets more of the dash tgether and the car painted

marks notch 8.41@163 on 16psi at atco saturday

fired off the 240 today!

butchered some fuel line stuff together today for the regulator and rails and threw the starter in the car, and fired it with an unknown base tune in there, haha still fired!

dougs nova on the rollers

swapped out the dyno brakes today

replaced the brakes on the dyno today after 11 years or so, quite a bit of wear when you compare to the new pads! working great and ready for the dyno day this saturday!

Matts 79 corvette ls swap!

get it working then clean it up!?

this is the wiring i threw together quick for my neighbors corvette, 79 vette with a silverado 4.8 and 60e swapped into it, i like to use wire nuts to make sure everything is working before you permanently wire it, then after it was all working he cleaned it up nice and neat on the right side, looks stock!

Threw two of donovans cars on the dyno today for a fall touch up

88 notch
08 ly6 junkyard 6.0 turbo cam, cast 80mm Borg warner springs, stock head bolts and gaskets etc motor never been apart, microsquirt, 80lb injectors th400, ptc billet converter, 3.55 gears, 28 inch slicks

pumpgas meth
16psi 15deg timing

02 trans am
06 6.0 iron motor, old nitrous cam, stock heads, billet 80mm borg warner, 4l80e, stock pcm, 80lb injectors, 16psi 13deg timing ford 9 inch rear, unlocked yank converter. 8 year old valvesprings

marks mustang makes 923whp on pumpgas and over 1000 on race

240 update video

cop car on the rollers

threw the sloppy cop car on the dyno for some initial dyno pulls

there is many small issues to fix but at least its making power and thats progress lol

240 driveshaft

Picked up the 240 driveshaft today from associated trucking looks perfect

i finally made my first hitler spoof video