Lots of progress today kiddies, clutch, headers, crossover pipe installed, motor dropped in, transmission installed, drive shaft hooked up, starter, wastegate installed, oil relocation kit installed, power steering hooked up and installed, clutch line adjusted, boost controller installed... almost everything. Basically gotta drop in the radiator, pour in some coolant and oil, and double check everything, install the compressor piping, upper intake manifold, distributor, plugs and wires, and start it up and set the timing, if all is well we can put the wheels on and take her for a quick tuning run.

More progress and pics tomorrow.

So, today the cam chain cover, water pump, rockers, push rods, balancer, oil pan, etc went on. Tomorrow it will be ready for the turbo kit and flywheel clutch bell housing, and then it can be dropped in. as always here are some pics.

     

installed the heads, lower intake manny

Well, today ryan installed the heads, and lower intake manifold. Cleaned up the cam chain cover and getting it all setup to pile together tomorrow night. Here is a nice action shot

tractor pull video... the start of sloppy mechanics

on my birthday in 2006 my friends took my video camera to a tractor pull event to get the soot flying on video for me. thus creating the first post after i built the website, where it all starts haha.

enjoy...

I could not make it to the tractor pull since I am going out to eat with the family for my birthday. Ryan was on location with my video camera to capture the events. Please Enjoy the tractor pull compilation